Note:
Turn off the unit and unplug it before any maintenance or cleaning, to avoid electric
shock.
1. Cleaning
Clean the surface of the unit with a soft duster or a soft damp cloth. Do not use chemical
solvents like benzene or alcohol etc. These may damage the housing.
2. Clean the air filter
If the air filter is blocked with a lot of
dust, the efficiency will be impaired. You
should clean the filter every two weeks.
A) Pull out the air filter as shown.
B) Wash the air filter by immersing it
gently into warm (under 40°C or 104°F)
water with neutral detergent. Rinse the
filter and dry it in a shaded place.
C) Push the air filter back into the original
position.
End of season
1.Remove the rubber drain plug from the bottom of the unit and drain into a suitable
container. You can remove the water entirely by carefully tilting the unit back. After the
water is drained select Fan mode and press the Fan button for 5 seconds until the lower
fan works. Then operate the unit in fan mode for half a day until the pipe is dry. This
drys the inside of the unit thoroughly preventing mildew.
2.Switch off the unit and disconnect the plug from the power supply.
3.Remove the air exhaust duct carefully and pack away.
4.Wrap the unit with a plastic bag, and keep in a dry place.
5.Take the batteries out of the remote control.
Maintenance
Page 11
This product has a self-evaporative system. The condensing water will recycle to cool
the condenser. This improves the cooling efficiency, decreases noise and saves energy.
When in cooling mode, the water from the evaporator will flow into an internal tray.
When the water reaches the lower level, an internal pump will recycle the water to cool
the compressor.
When the internal water tray is full, the Water Full indicator will light and the compres-
sor will stop working. The buzzer will buzz 10 times every 5 minutes until the water
level drops below the high level or is drained. The unit will then work normally after a
delay of approximatelly 3 minutes.
The water can be drained using the drain pipe.
It is included in the accessory. Place a container
under the drain plug to catch any water whilst
affixing the hose
Move the unit gently when the internal water
tray contains water to ensure that water does
not spill from inside the unit.
If the internal water level is to low the pump will
stop and the Water Injection indicator light. The
injection port should be pulled outwads and water
poured into it. (No higher than the high level). This
will help to save energy.
Water Drainage Methods
PAC-15000-A
Page 10
www.alaskanaircon.com
