3
MOUNTING AND INSTALLATION
Install Cylinder
1. Install Cylinder if not already installed at the fac-
tory.
Screws A & B (see Fig. 1) are correctly set at
factory. If it is difficult to screw in the cylinder,
loosen the two screws near the actuator (A) one
turn. If you find the cylinder is still difficult to screw
in, then loosen the other screws (B) one turn.
Do
not loosen the screws all the way or it may be
difficult to replace them properly! Note:
The trim
is manufactured to use a 1-1/8" or 1¼"
Alarm Lock
mortise cylinder with a HW-1302 cam. If the cylin-
der that will be used is longer than 1¼", a collar
must be utilized. Please see the collar information
on the previous page.
1a. Insert key
half-way
into the cylinder, then screw
it in.
See Fig. 1a. If cylinder will not seat flush, the
cylinder back stop screw may require loosening.
Cylinders that are longer than 1¼" will require a col-
lar, which will stick out from the surface when cor-
rectly installed. Please see the cylinder information
on the previous page.
1b. After the cylinder is screwed in all the way, cen-
ter the keyway toward the bottom
(see Fig. 1b). If
an interchangeable core cylinder is utilized, then
center the interface toward the bottom. Tighten the
screws that were loosened in step 1.
1c. Remove the key. Use a 1/16" hex wrench to
screw the cylinder
back stop
screw in fully. (See
Fig. 1c)
The key should now only rotate
counter-
clockwise
.
NOTE:
To remove cylinder, reverse steps 1a-1c.
Install the Lever
2. Install the lever with proper orientation
for the
lock/door hand used. Tighten the set screw using a
1/8" hex wrench (see Fig. 2).
IMPORTANT!
The top of the set screw must be at
(or below) lever surface. If not, check to ensure the
lever is fully pushed toward the trim.
Prepare the Door For "Through-Bolting"
3. Remove the existing panic/exit device to reveal
its mounting hole locations.
Place the template
on the door, aligning the holes shown on the tem-
plate (labeled "Existing Mounting Hole Locations")
with the existing exit device mounting hole locations
in the door.
The template must also remain parallel
to the edge of the door at all times
. Reposition the
template as often as needed until it is placed cor-
rectly.
3a.
As labeled on the template,
drill completely
through the door for the four (4) 7/32" diameter
through-bolt mounting holes and the 7/16" di-
ameter battery cover access bolt hole.
•
IMPORTANT!--Drill the holes STRAIGHT
THROUGH the door, or the through-bolts will not
Fig. 1b: Center keyway toward bottom
Fig. 1c: Use 1/16" hex wrench to screw in
the cylinder back stop screw
Fig. 2: Tighten lever set screw
with 1/8" hex wrench
Fig. 1: Install Cylinder if not already installed at the factory
A
B
Cylinder
back stop
screw
Fig. 1a: Insert key 1/2 way into
cylinder and screw in
Содержание DL1200ET
Страница 7: ...7 NOTES ...