Alarm Lock AL-IM2-80211, Руководство по установке

Страница: 5 / 8

5
GATEWAY LED INDICATIONS
CLOSE HOUSING COVER
Close the housing cover by first engaging the hooks at
the top, then snapping the bottom together. Secure
the cover with the Bottom Screw provided as shown in
Fig. 6.
Congratulations! You're finished!
Now go to the
DL-WINDOWS™ for Networx™ V5 USER'S GUIDE
(OI383) for instructions about discovering your Gate-
way from DL-Windows.
network), the Gateway was
unable
to receive a val-
id IP address from the network. However, the
Yel-
low
LED will still turn on solid and the
Green
LED will still flicker.
Do not confuse this with the
above valid IP address indication
.
Refer to the flowchart for a visual representation of the
above process:
Next, reset the Gateway as follows:
Reset the Gateway
IMPORTANT:
Before securing the Gateway hous-
ing cover, ALWAYS reset the Gateway memory, even
if the Gateway is new "out of the box" and/or has nev-
er been used previously.
After initial power up, press and hold the
RESET
but-
ton (see below for location); continue to hold the but-
ton until the red LED turns on solid. Now, release the
button and the green LED will flicker rapidly.
Always reset the Gateway for new installations; you
can also reset the Gateway any time after the Gate-
way is powered. Two levels of reset exist, a "Normal"
reset and "Factory" reset, as follows:
Normal Reset:
Clears Gateway memory and user
data allowing for re-discovery by DL-Windows. Press
and hold the
RESET
button until the
Red
LED turns
on solid, then release the button and the
Green
LED
will start to flicker rapidly.
Factory Reset:
Clears Gateway memory, user data
and configuration data (such as static IP information),
thus returning the unit to its original factory settings.
Press and hold the
RESET
button, the
Red
LED turns
on solid; keep holding until the
Yellow
LED also turns
on solid. Release the button; the
Yellow
LED will re-
main on solid, and the
Green
LED will start to flicker
rapidly, indicating a full factory reset.
Note:
Resetting the Gateway (Normal or Factory)
does NOT cause the Gateway to search for a new IP
address.
After a reset, power cycle the Gateway to
initiate a new IP search
.
Fig. 6: Bottom Screw
Yellow
Red
Transmitter On
Green
(Gateway Status)
Not configured - Rapid blinking / flickering
Idle / configured - 1 blink per second
Lock Communication Fail - 2 blinks
(continuously)
Expander Communication Fail - 4 blinks
(continuously)
Receiver On (normal operation)