To exit the program mode press the key.
To set the relay on time press
then enter the relay on time, (relay on time is from 1 to
999 seconds), then press the key. The Yellow Led will flash twice and you will hear two
beeps. The relay on time has been entered.
You must be in the Program Mode
4 0
In the event a User Code must be deleted do the following, press then enter the User
Number then press key. The Yellow Led will flash twice and you will hear two beeps.
The selected User Code has been deleted.
You must be in the Program Mode.
#
#
You must be in the Program Mode
The User Codes can be from 4 to 8 digits in length, (digits can be repeated).
The User Codes must not be the same as the Installer Code
Press the key then enter the User Number, this number is two digits long and range
from
00
to
99
, then enter the user code, then press the key. The Yellow Led will
flash twice and you will hear two beeps.
You can now enter the User Codes.
An Installer Code must be entered in order to activate the Program Mode the first time.
1.
Enter then press the key. The Yellow Led will be on steady, you will hear
two beeps. You will now be able to enter an Installer Code.
2.
Press then enter an Installer Code that can be 4 to 8 digits in length,(digits can
be repeated), then press the key. The Yellow Led will be on steady, you will hear two
beeps. You are now in the
Program Mode
. Please record the Installer Code for future
use.
The Installer Code may be changed by entering the old Installer Code and repeating #
2
.
PAGE 3
0
0
0
1
1
0 0
*
*
#
STEP 2 KEYPAD INITIATION MODE
Connect power to keypad. Voltage can be 12 or 24 AC or DC. When using DC voltage pola-
rity must be observed. Keypad has an auto voltage sensing circuit that detects the applied
voltage.
THE FOLLOWING STEPS MUST BE TAKEN TO ACTIVATE THE KEYPAD !
STEP 3 ENTERING THE USER CODES
STEP 1 ACTIVATING THE PROGRAM MODE
The Keypad Initiation Mode allows 100 user codes in code lengths from 4 to 8 digits with
more than 100 million code combinations.
This procedure must be followed !
To activate the Keypad Initiation Mode enter then press the key. The Yellow
Led will flash twice and you will hear two beeps. You are now in the
Keypad Initiation Mode.
8 9 0 1
#
#
EXAMPLE OF ENTERING A FOUR DIGIT USER CODE
DELETING A USER CODE
SETTING THE RELAY ON TIME
LOCATION
USER NUMBER
USER CODE
1
TO ENTER PRESS
#
2
0
1
8
3
5
TO EXIT THE PROGRAM MODE
EASY START UP
