Questions? Contact Alarm.com Dealer Support at
1.866.834.0470 or [email protected].
Alarm.com, Inc. © 2000 - 2010 All rights reserved.
www.alarm.com
INSTALL
Hardware Installation:
Secure the camera to the wall/ceiling using the supplied camera stand. Note: If camera
is ceiling-mounted (with logo upside down), you will need to invert the camera image so
live and recorded video does not appear upside down. This setting can be changed on
the Camera Image Settings page.
The camera comes with a pre-installed cable, but it can be replaced with a custom cable
by using the spare 3-hole, water-tight connector that is included with the camera.
Weatherproofing the Camera:
The camera is weather-sealed at the factory, but if it is opened in a
humid environment the supplied silica gel pack should be installed to
prevent fogging of the lens.
1. Loosen the black plastic cable nut, and then pull out the black
plastic cable seal.
2. Unscrew the metal back cover of the camera body.
3. Remove the silica gel pack from its plastic pouch, but do not open
the silica pack itself. Secure the silica gel pack to the inside of the
camera housing using double-sided adhesive.
4. Make sure all cable lines are securely connected.
5. Tighten the back cover, rubber seal, and black plastic cable nut.
Physical Details:
Notes:
The Infrared LEDs provide illumination of up to 30ft for
nighttime video viewing and recording.
Operating temperature range is -4 to +122 F
(-20 to +50 C).
Power over Ethernet – PoE (Optional)
This camera model is PoE-compatible, allowing it to be powered by the Ethernet cable if
connected to a PoE power injector installed at the network router.
With this installation configuration, the camera’s power wire and AC power adapter are not used.
