2
Installation
Step 1: Install the Hub
1. Plug the AC adapter into an unswitched outlet. (This is an outlet that is always “on,” and
can’t be controlled by an on/off light switch or dimmer switch.) Connect the other end of the
AC adapter to the Hub’s DC IN port ( ).
o
The Hub’s Status Light will display an animation of a white LED moving back and forth
followed by the Hub’s Status Light blinking white. Once the Status Light stays solid
white, you can continue the setup process.
o
The Cellular Hub will then take up to five minutes to register with Building 36 servers.
Note
: During this time, install each Z-Wave Device around the home.
Step 2: Adding Z-Wave Devices
To add Z-Wave devices, each device must be within direct communication range of the Cellular
Hub. For best results, we recommend having the Cellular Hub in the same room as the device
you wish to add to your network. If necessary, unplug the Cellular Hub to move it into direct
range of the first Z-Wave device. The Hub can use its internal battery when it’s not connected to
the power supply.
Add Z-Wave Devices Locally
1. Press the Menu button once to navigate to the Add Menu. The Status Light will be solid
green.
2. Press the Select button to put the Hub in Add Mode. The Hub’s Status Light will blink
green when in Add Mode.
3. Follow the Z-Wave device’s instructions to put the device into Add Mode.
4. The Hub’s Status Light will display an animation of a green LED moving back and forth
when the Hub is adding a device.
5. The Hub’s Status Light will turn solid green once a device has been successfully added
to the network.
6. Repeat Steps 2-5 for any additional device you wish to add to the network.
Step 3: Complete the installation
1. Once all devices have been added to the Hub, place the Hub in its permanent location
and plug in the power supply to the Hub.
2. Continue account setup on MobileTech or Partner Portal.
