Alarm.Com ADC-CSVR2000P, Руководство по установке

Страница: 12 / 16

10
Notices
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Rated:
- ADC-CSVR2000P - 12Vdc, 5A, 60W
- ADC-CSVR2008P - 100-240Vac, 60-50Hz, 3.5A, 200W
- ADC-CSVR2016P - 100-240Vac, 60-50Hz, 6-3A, 280W
• The NVR is only to be connected to PoE networks without routing to outside plants.
• Ensure that all maintenance and repair work is handled by qualified personnel such as
electrical engineers or network specialists.
• Connect the system to an earthed main power outlet.
• CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.
IMPORTANT: The total power budget for the ADC-CSVR2008P POE ports is 120W, ADC-CSVR2016P POE ports
is 200W. Every 8 ports (#1 ~ #8 or #9 ~ #16) provides 100W.
• The maximum output for each port is 30W. If a PoE device draws more than 30W, then PoE Power will be
disabled on that port.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.