AL-KO Vario X, Инструкции

Страница: 2 / 4

en
SAFETY INSTRUCTIONS
Risk of accident due to damaged chassis.
Improper use may result in damage to or bre-
akage of the chassis.
If damage to the chassis is suspected, contact
AL-KO Service.
Observe the following points to avoid damage:
Do not weld, cut or drill on the chassis!
Do not tie anything over the lightweight reces-
ses of the chassis!
Do not clamp, brace or lash anything to the
vertical bars of the chassis!
Do not brace accessories (e.g. bicycle rack)
over the entire height of the drawbar section.
This will damage the chassis!
Possible mounting positions:
To avoid damage to the chassis, support over
a length of at least 200 mm !
Alternatively, brace it from two points with a
distance of at least 200 mm .
min. 2
00 mm
min. 2
00 mm
CAUTION!
Drawbar adapters for clutch carriers
are not approved!
When lifting the caravan with a hydraulic
ramp:
Do not place the hydraulic ramp support
plate on the chassis; place it on the cara-
van floor as close to the chassis as pos-
sible.
Choose the largest possible mounts (ap-
prox. 10 x 35 cm).
Ensure that the mounts lie flat, i.e. that no
cables or other attachments prevent a flat
support.
Select mount positions according to the
following sketch.
4 695889_a