AL-KO SOLO Robolinho 1200, Руководство пользователя

Страница: 60 / 432

GB
60 Robolinho 700/1200/2000
Help in case of malfunction
Malfunction Cause Remedy
Rechargeable battery oper-
ating time is significantly
shorter. Cutting height level is too
low. Increase the cutting height, then lower
in stages to the required height.
Grass is too long or too wet.
■
Let the grass dry.
■
Set the cutting height to a higher
level.
Appliance vibrates or the
volume is too high. Imbalance on the cutting
blade or in the cutting blade
drive
■
Clean the mower deck.
■
Contact an AL-KO service centre.
Rechargeable battery can-
not be charged or low bat-
tery voltage
■
The charging contacts of
the base station are dirty.
■
The contact surfaces on
the appliance are soiled.
Clean the charging contacts and contact
surfaces.
Base station has no power. Connect the base station to the power
source.
■
The appliance does not
touch the charging con-
tacts.
■
The contact surfaces on
the appliance are burned
out.
■
Place the appliance in the base sta-
tion and check that the charging
contacts make contact.
■
Contact an AL-KO service centre.
The service life of the re-
chargeable battery has ex-
pired. Contact an AL-KO service centre.
The charging electronics are
faulty. Contact an AL-KO service centre.
NOTE
If you encounter any malfunctions that are not listed in this table or that you cannot rectify
yourself, please contact our customer service.
14.2 Fault codes and troubleshooting
Fault code Cause Remedy
CN001: Tilt sensor
The inclination sensor has
been triggered:
■
Max. tilt exceeded
■
The appliance has been
carried
■
Slope too steep
Place the appliance on a flat surface
and acknowledge fault.
CN002: Lift sensor
The lift sensor has triggered:
■
The appliance cover has
been deflected upwards
by lifting or by an obsta-
cle.
Remove the obstacle.