AL-KO GTLi 18V, Руководство по эксплуатации

Страница: 17 / 172

Startup
440084_c 17
3. Push the auxiliary handle onto the holder
(3-2).
4. Engage the auxiliary handle in the splines.
5. Place the tip lever with pin holder onto the
clamping pin.
6. Screw the clamping pin tight so that the tip
lever can be operated with little force (3-3).
STARTUP
CAUTION!
Always perform a visual check prior to
start-up.
CAUTION!
Do not use damaged batteries. Danger
of fire!
CAUTION!
Danger of explosion and fire!
The charger heats up during charging.
Do not place it on a flammable surface or
in a flammable environment.
Charging the battery
ADVICE
The battery is supplied partially charged!
Fully charge the battery before the first
use.
The battery can be charged in any
charge level. Interrupting charging does
not damage the battery.
ADVICE
The battery is protected against exces-
sive charging by a supply voltage control
function, which means it can be left con-
nected to the mains for some time.
1. Connect the charger (1-5) to the mains wi-
thout the battery (1-4). The LED on the mains
adapter lights up green.
2. Connect the battery to the charger. The LED
on the mains adapter lights up red. Charging
starts.
ADVICE
The temperature range for charging
should be between 5 and +45 °C.
The charging time for a full charge is
max. 200 minutes. If the operating time
of the battery is significantly shorter in
spite of full charging, this indicates the
battery service life has expired and it
must be replaced by a new, genuine bat-
tery.
3. The charging process has finished when the
LED on the mains adapter lights up green -
the battery is fully charged.
4. Disconnect the charger from the mains.
5. Remove the battery from the charger.
Inserting the battery
1. Press the locking catch.
2. Push the battery along the guide until the con-
tact socket on the battery is firmly located on
the contact plug of the appliance.
Adjusting the telescopic handle
1. To release, turn the upper locking sleeve
through about 180° to the right (4-1).
2. Set the telescopic handle to the individual
physique. The telescopic handle can be ex-
tended by approx. 10 cm (4-2).
3. Tighten the locking sleeve (4-3).
Swivelling the cutter head
To trim lawn edges, for example, it is possible to
swivel the cutter head through 180° (5, 6).
1. Loosen the lower locking sleeve (5-1).
2. Turn the telescopic handle through 180° (5-2).
3. Screw the locking sleeve tight (5-3, 6-1).
Angling the cutter head
By changing the pivot angle, it is also possible to
trim areas that are difficult to access, e.g. under
benches, overhangs, etc.
1. Press the locking button (7-1).
2. Engage the cutter head in the required angle
(7-2).
3. Release the locking button.
ADVICE
Remove the guard on the line cutter be-
fore taking into operation for the first
time.
Starting the lawn trimmer
1. Stand securely.
2. Hold the appliance with both hands. Do not
place the cutter head on the ground when do-
ing this.
3. Hold the auxiliary handle in one hand and the
upper grip with your other hand.
4. Press the switch in the upper grip and hold it
pressed. The appliance runs.