32
akytec GmbH - Vahrenwalder Str. 269 A - 30179 Hannover - Germany Tel.: +49 (0) 511 16 59 672–0 - www.akytec.de
6 Configuration
6.1 Connection to akYtec Tool Pro
The Module is configured in the akYtec Tool Pro program.
The Device can be connected to a PC using the following interfaces:
– USB (microUSB),
– Ethernet.
To select an interface:
1. Connect the module to the PC using a USB cable or Ethernet interface.
NOTICE
If the module is connected to the USB port, the main module power supply is not required.
In case of connecting via Ethernet interface it is necessary to supply the main power to
the module.
2. Run akYtec Tool Pro.
3. Click the icon
Add devices
on the tool bar.
4. In the drop-down menu "Interface" select:
– Ethernet (or other network card to which the module is connected): for Ethernet connection;
– STMicroelectronics Virtual COM Port: for USB connection.
Fig. 6.1 Interface selection menu
The next steps for finding a Device depend on the choice of interface.
To find and add a Device connected to the Ethernet interface to the project:
1. Select "Find device"
2. Enter IP-address of the connected device.
3. Click Find. A Module with the specified IP address is displayed in the window.
NOTICE
The default IP address (factory setting) is
192.168.1.99
.
4. Select the Device (place a check mark) and click OK. If the Device is password protected, you
must enter the correct password. The Device will be added to the project.
To find and add a device connected via USB interface to the project:
1. In the drop-down menu, select the akYtec Auto Detection Protocol.
Fig. 6.2 Select Protocol
2. Select
Find device
.
