Quick Guide
A01X/A02X
For the convenience of the
installation, it is advised
that you lead the rope we
provided through the rope
hole at the back of the device,
then fill in the grove using the
silicone foam strip.
Hang the rope onto the
hook hanger on the
junction box.
Insert RJ45 cable (with no sleeve attached) and press down the
terminal slot using the pry tool to secure all the signal wires in
their corresponding slot.
Note:
1.
M
ake sure that all the connection wires are organized under the
wire organizer.
2.
I
f the RJ45 extension cable is with a sleeve, then you
should insert RJ45 Ethernet patch cable instead and connect it to
the RJ45 coupler Ethernet connector before connecting the RJ45
cable (with sleeve) to the connector otherwise it can not be
properly sealed against the water.
4
Step2:Back Cover Installa on
Plug the rubber plug into the corresponding plug opening in the
direction as indicated.
Note: When there is only one Ethernet cable,you should select small
size rubber plug if the signal wire is less than 6 in quantity. Select
medium size rubber plug if the signal wire is 7-10 in quantity. Select
large rubber plug, if the signal wire is 11 or more in quantity.
Insert the cable locking
plate and tighten it using
4 M2.5x4 screws.
Make all cables go through
the groove of the cable locking
plate, then hang the device
onto the junction box mounting
bracket while pushing it down
against the corresponding hook
hanger.
Wire
organizer
RJ
45
Ethernet Patch Cable
RJ
45
Coupler
Ethernet
RJ
45
Cable with sleeve
Extension Connector
