Akura MB18 IDTV, Руководство пользователя

Страница: 24 / 34

- 24 -
DUAL I
If dual broadcast detected. Dual I is selected
in default and also can be selected after
Dual II by Remote Control.
DUAL II
If Dual II selected by Remote Control.
Picture Mode
Picture mode can be changed to
Auto,fill all
or wide by pressing the WIDE button.
Mute Indicator
Appears in the upper right of the screen
when enabled, and it stays there until it is
disabled.
To cancel mute, there are two alternatives;
the first one is pressing the button so that
the volume is set to the preceding value, and
the second is increasing the volume level.
By decreasing the volume level in mute
state, mute will not be ignored, only the vol-
ume level will decrease. If mute is canceled
after decreasing the volume level, the vol-
ume will be valid with the decreased level.
No-Signal Detection (TV)
If no valid signal is detected, the TV will
switch to stand-by mode after 5 minutes, un-
less any signal detected or no any Remote
Control command is accessed.
After a Remote Control command (if No-Sig-
nal Timer is active) the timer stops and if no
signal is detected again the timer is initial-
ized to 5 minutes and starts 3 seconds later
again to count down.
It is not valid in AV mode.
Volume Bar
The volume bar is displayed in the lower
middle of the screen. When a volume com-
mand is received (pressing “ +”
or
“-
”
on the remote control or control panel
at the right side of the TV) and no menu is
active, it stays on the screen for 3 seconds,
after the last volume command or until an-
other command is received in between.
AV Modes
By pressing the
AV
button you can switch
your TV to AV modes (except being in Tele-
text). Pressing this button consecutively will
switch the TV in one of the optional AV
modes: AV-1, RGB1,AV-2, SVHS, IDTV.
In order to quit the AV mode press the “TV/
DTV”, digit buttons or
“-P/CH”
or
“P/CH+”
.
Teletext
Teletext is an information system that dis-
plays text on your TV screen. Using the Tele-
text information system you can view a page
of information on a subject that is available
in the list of contents (index).
On screen display is not available in text
mode.
Contrast, brightness or colour control is not
available, but volume control is available in
text mode.
To Operate Teletext
• Select a TV station where Teletext is being
transmitted.
• Press the “ ” button. Usually the list of
contents (index) are displayed on the
screen.
ENG-20700-20 INCH TFT-BACK AV-1549UK-MB18 IDTV-(WO PIP-WO PC)-50093041.p65 06.09.2006, 17:37 24