5
3. ASSEMBLY AND INSTALLATION
Assembling the frame
Fitting the mat and installing the springs
Lay the frame sections (Part A) into a circle
with the spring holes facing upwards. Push
all sections together until all are fully mated
together.
Lay the mat flat inside the frame. Make sure the logo is facing upwards. In order to make the installation of the
jumping mat easier, locate the four rings in the 12, 3, 6 and 9 o’clock position directly opposite each other and
attach four springs on these locations first. Then continue by attaching springs to every eighth ring, followed by
every fourth and so on until all springs are attached.
We recommend at least two people to assemble the trampoline. Use gloves to protect your hands from pinch points and
sharp points during assembly. Do not apply excessive force during assembly that will cause damage to the product.
TOOLS
:
You will need a cross-head screwdriver for the retaining wall PVC panels.
Important
:
Be sure all spring hooks
are well attached to the frame.
1
2
Note: On the long sides, the frame will appear to bow outwards - this is by design. When the springs are attached the frame will
pull inwards, but always have a slide outward bow.
Important note: all trampoline sizes are approximate and can be up to +/- 2,5 cm / 0,8’’ different to those that
we publish.
At first, it may look like the mat won’t fit, it will
however stretch to the correct size when you
finish attaching all springs.
