Akrobat GRASSHOPPER, Инструкция по установке и эксплуатации

Страница: 6 / 16

6
INSTALLATION AND USER MANUAL - GRASSHOPPER
Digging the trampoline pit
Position the frame on the location you chose and mark the position on the ground. It’s best to
mark out a hole a bit wider than the diameter of your trampoline.
This will make it easier for you to put the frame in and find the right level. Dig the pit to the
following dimensions:
Start digging the hole
15 cm
inside from the frame diameter, deepening the pit towards the middle,
where it needs to be
90 cm
deep.
When the hole is dug, place the trampoline
above this pit. Make sure the jumping mat is
positioned precisely above the hole.
Fix the legs of the trampoline with the pins. Push
each pin through the hole on the trampoline
leg as shown on the picture. Make sure the pins
are firmly attached to the ground.
TRAMPOLINE SIZE
Dimension A – Frame diameter Dimension B – Pit diameter Dimension C – Total depth
10x6ft / cca. 305x183 cm 275 x 153 cm 90 cm
11x8ft / cca. 335x244 cm 305 x 214 cm 90 cm
4
AKROBAT HINT:
It’s a relatively easy task to hand dig the hole for smaller size trampolines, but it would be best to hire a
mini digger able to excavate most of the soil and leave you with the finishing touches.
3
Placing the trampoline above the pit
The hole should not accumulate water (in which case the drainage is necessary) and it should be
possible to clean during maintenance.