Installing the thermal paper roll
AKO-15742/15752/15782 only
-With the unit connected to the network, open the front cover
and push the release lever (1) back.
-Place the paper roll in the position shown on the image.
-Push the end of the paper through the bottom slot of the printer
until the latter starts to pull it. When the paper comes out of the top
slot, return the release lever to its initial position, the printer is ready
to print.
-Press the
E
key to feed the paper through.
-Press the
D
key for express printing.
To print data, the data logger has to have at least one entry recorded.
The required printing time will depend on the entry interval configuration (default is 15').
IMPORTANT:
The printer paper is thermal and can only be printed on one side. Make sure you insert it
properly.
Start-up
Connect the power supply of the device and enter the configuration menu pressing the
SET
key for 5 seconds.
Configuration changes are applied when you exit, the device will ask you if you are sure about the changes made.
Basic configuration
Language selection
Select the most adequate language
using the
N
and
Q
keys, press
SET
to
accept the changes.
Date and time
Set the current date and time using the
P
,
O
,
N
and
Q
keys, press
SET
to accept the changes.
Input configuration
Select the input type as required using the
N
and
Q
keys, press
SET
to accept the changes.
Repeat the action for each input used. If you do not use an input, configure it as disabled.
1
SET
SET
SET
SET
SET
16
1575H031 Ed.01
Содержание AKO-15740
Страница 57: ...1575H031 Ed 01 57...
Страница 58: ...1575H031 Ed 01 58...
Страница 59: ...1575H031 Ed 01 59...
