6
Model No: CT-14NI9R
Version 1.0
ALIGNMENT INSTRUCTION (3S10)
1. Preface
This ADJUST MANUAL is only used for 3S10 chassis, and guides to make adjust equipments. It
is only a reference.
2. Instruments For Adjustment
a. TV signal generator
b. 20MHz 2-channel oscilloscope
c. Adjust jigs
d. Sweep Signal Generator(option)
e. Digital voltmeter
f. White balance adjust equipment.
3. How To Enter And Exit Factory Mode
a. Enter factory mode by pressing MENU button, AV button and ANAL button in turn or
pressing the SERVICE button (
on the right of MENU button, we can add this button for
easy to enter service mode in factory
). Press OK to enter Service 2.0 and Design mode.
b. Exit factory mode by pressing PP or pressing STANDBY button.
4. Chassis Adjust
4-1. VCO Adjust
a. Set TV Signal Generator to output a 38.9MHz, stranger than 80dBuv PAL color bar
signal.
b. Signal inputs to TUNER’s IF terminal or pin5 of SAW101 through a 0.01UF/50V
capacitor
c. Connect 220V AC (50/60Hz) and Switch on power switch. Enter Service 2.0 menu.
d. Press AV button after picking out
VCO Coarse
or
VCO Fine
item by PROG+/- buttons.
VCO is well adjusted automatically if the character OK appears at the bottom of screen.
(If OK can not appear automatically, please fine tune LC238 and re-try again)
e. The following adjustment is suitable for TV sets with SECAM L/L’ system.
Set TV signal Generator to output a 34.4MHz Signal, set TV set to
VHF-L
band. Press
AV button after picking out
VCO Coarse L1
or
VCO Fine L1
by PROG+/- buttons. The
VCO of SECAM L’ system is well adjusted if the character
OK
appears automatically at
the bottom of screen.
Note: After VCO is well adjusted, exit factory mode by pressing PP button at first, switch
off power switch, then withdraw IF signal.
4-2. IF Trap(LC101) Adjust For RF NTSC
a. Receive RF NTSC signal.
b. Adjust LC101 until picture is best.(We also can use a sweep sigmal generator to get best
the trap point)
4-3. AGC Adjust
a. Receive 60dBuV RF signal.
b. Enter Service V2.0 mode and get
Tuner AGC PAL
item, adjust PAL AGC by VOL+/-
buttons until picture’s noise just disappears and no distortion under 100dBuV level.
c. If TV has SECAM LL1 system, enter Service V2.0 mode and get
Tuner AGC LL1
item,
adjust SECAM LL’ AGC by VOL+/- buttons until picture’s noise just disappears and no
distortion under 100dBuV level.
c. If TV has SECAME LL1 system, press OK key to enter design menu, set AGC Gain PAL
to 1,set AGC Gain LL1 to 3
Содержание CT-14NI9R
Страница 13: ......
