12162021JA
www.akiascreens.com
U-00206
6
Note (after all springs have been attached):
Correct material installation
–Corners of the screen material are properly wrapped around the corner edges of the
frame and material is evenly tensioned and flat, creating a nicely taut surface.
How to avoid getting ripples on the screen’s material surface
Solution:
With the gloves on and assuring they are clean,
pull and smooth out the material using your hand from the
center to the corners, creating a nicely taut surface as shown below.
Incorrect material installation
–The corners of the screen material are not properly wrapped along the edge of the
frame leaving the material with unbalanced tension and an uneven finish. To correct, detach springs from material at
the corner(s) where material does not lie flat along the edge of the frame, reposition the material so that it lies flat
and wraps along the edge of the frame, and reattach springs to the material.
Attention: Do not proceed with the Edge Trim installation until making sure there are no ripples in the material.
Edge Trim Installation
Step 10
: Place the edge trim frame
pieces over each end of the frame.
Connect edge trim frames (
E/F
) together using the
Center Joints- M4(a)
and secure with four of the
M4x4 Screws(m)
as shown in
Step 1
. Repeat for other side.
Once both top and bottom edge trim frames have been connected, attach the vertical (left/right) sides edge trim
frames (
D
) using the
Elbow Joints M4 (c)
and secure with four
M4x4 screws
(
m
) on all corners,
Step 2
.
ATTENTION: The back of the material has labels indicating the TOP and BOTTOM. The top edge trim piece with the
logo should be installed at the top. The material is directional and will not accurately reflect if bottom side is projected on.
c.
a.
m.
2.
1.
m.
1.
2.
2.
