AKE Stealth Bluetooth Helmet Set NG, Инструкции по эксплуатации и монтажу

Страница: 26 / 32

26
ENGLISH
helmet set. The function display will flash blue and is than flashing to indicate
availability. Paired device will connect automatically, if this are set to „autocon-
nect“. Press the multi functional button for approx. 3 sec. to turn off the Bluetooth
helmet set. The switching off is indicated by a red light showing in the display.
Activate voice connection from helmet to helmet
For that, please press the multi functional button at one of the Bluetooth helmet
sets. The intercom will automatically be connected after approx. 2 - 3 seconds.
Both helmets put on the heads, otherwise it could lead to feedback effects.
To cancel the voice connection also press briefly the multifunction button (8). Then
both units go to stand-by mode.
In a noisy environment, it is advisable to activate the hands-free connection only when
needed, thereby also extended the battery operating time.
If all partner have a mobile phone with Bluetooth interface, can be very easy * also
establish a voice connection via GSM. This mode offers the following advantages:
1. Practically unlimited range and no shadows from walls, etc.
2. Voice communication between up to 6 or more partners(network dependent).
For voice communication with multiple devices, each additional participant via
Å Å Å
mobile phone include as follows: (2) ( ) (Phone number)( ) (3) ( ). With many
phones, there is also a button "Add call".
*) without flat may be additional costs.
Using a navigation system
The Stealth Bluetooth Helmet Set NG is compatible with all navigation systems that
work with hands free profile (HFP) and / or stereo audio profile (A2DP). After the
navigation voice announcements have ended, the intercom will automatically be
connected again in intercom mode.
Operating functions when using a mobile phone or smartphone
Calling tone: Adjust your mobile phone in such a way that the ring tone in the
helmet is heard. For the setting of the ring melodie
Please note that when operating with two Bluetooth units the
internal communication must be activated even after switching
both units!
Bluetooth originally was made as a worldwide uniform standard. Unfortunately, some
producers do not comply to regulations. Therefore it might lead to imcompatibilities.
For further information please check our FAQs on our website.
automatic call acceptance
should not be too short as the start of the signal will be lost when audio is in