Maintenance
Cleaning the stylus A
A dirty stylus will cause noise and poor sound quality. Use a stylus cleaning kit and brush off
the dirt in the direction of the arrow.
Do not brush in the opposite direction or from side to side, since this can damage the stylus.
Replacing the stylus B
When the sound quality drops, replace the stylus with a new one. Remove the old stylus by
pulling it downwards gently, and push the new stylus into place as shown..
Maintenance of external surfaces
Use a polishing cloth or dry cloth to wipe off dust and dirt.
When the surfaces are very dirty, wipe with a soft cloth dipped in some neutral cleanser
diluted five or six times with water, and wrung out well, and then wipe again with a dry
cloth. Do not use furniture wax or cleaners.
Never use thinners, benzene, insecticide sprays and other chemicals on or near this unit,
since these will corrode the surfaces.
Specification
GENERAL
Power supply:
AC 230V/50Hz
Power consumption: 3W
Dimensions:
350 x 348 x 95.4 mm
Load Impedance:
47K ohm
Output Voltage:
A.Connect with Equalizer
90-216mV at 1KHz 5cm/sec(HP-4005)
B. Connect without Equalizer
1.5-3.6mV at 1KHz 5cm/sec(HP-4005)
Weight:
2,47Kg
Computer interface: USB 1.1 compliant Windows XP or MAC OSX
A
B
18
