Akai ATT-603, Руководство пользователя

Страница: 12 / 29

12
●Use the file, Edit, View, Project, Generate, Effect and Analyse menus to Save, Export
and Manipulate your music.
● If the recording level requires adjustment, click on ‘START’, ‘SETTINGS’ and select
control panel. Under Control Panel select ‘SOUNDS and AUDIO DEVICES’, click on
the ‘VOLUME’ tab and select ‘ADVANCED’.
● On the Master volume window select options at the top left hand corner, click on
properties in the drop down menu.
● In the Properties window select “USB PnP Audio Device “ from the drop down menu at
the top. Click on “OK “ to confirm the selection and a window will now appear with a
control for the recording level. Move this control up if the recording is too quiet and
down if the recording is too loud
● NOTE: the blue wave form should sit in the Audacity window such that the peaks of it
stop short of the top and bottom
● Before editing your music, the recorded waveform will need to be highlighted.
● To highlight your wave form, click with the left mouse button on the left hand side of
the waveform (under the L+R controls) and the waveform will go darker.
● At this point the whole waveform can be edited. However if only a section of the
waveform needs to be edited (or saved) the section required can be highlighted by
placing the mouse over the beginning of the section holding the left button down and
dragging it right over the area required and releasing it when the end of the desired
section is reached. This darkened section will now be the only audio that will be edited.
● Alternatively click on the "EDIT" menu at the top left and then click on "SELECT" then
choose from: "All" (whole wave form), "Start to Cursor" or "Cursor to end".
● NOTE: after recording to the Computer, the USB cable may have to be removed from
the USB port in order to enable playback later from the Computer.