Place the record of your choice on the turntable. If required, do not forget to place the adaptor on the
record spindle.
Choose the desired playing speed using the speed selection switch between 33, 45 and 78rpm.
Turn on the Rotary Power Switch, note that this also controls volume.
Release the tone arm lock.
Raise the arm with your hand lightly.
Place the stylus vertically over the first track of the record, the turntable will start turning automatically.
Put down the stylus slowly on to the record to play.
When a record comes to the end, the turntable will stop automatically if the auto-stop switch is in the ON
position. If the switch is in the off position then it will keep revolving all the time.
Lift up the tone arm and put it on the rest when finished.
Replace the protective cap on the stylus and close the tone arm lock.
Turn off power at mains.
MAINTENANCE
REPLACING THE STYLUS
-
Refer to the figures 1-8
To fit a new one just in opposite deals, insert the audio-line accordingly, and install the cartridge to the socket lightly.
Note :
Please exercise extreme care whilst performing this operation so as to avoid the tone arm and audio line wires
from any damage.
INSTALLING A NEW STYLUS CARTRIDGE
-
Refer to the figures 5 & 6
Push the arm lock to
release the tone-arm.
Take off cap of cartridge
to expose the needle
out.
Take off the audio-line
from the cartridges
completely.
Separate the
cartridge from the
socket lightly.
