Akai APRC50UC, Руководство оператора

Страница: 10 / 28

PRESET EQUALIZER
• This unit is equipped with a preset equalizer which has been added to enhance your listening
pleasure by altering the frequency response of the music.
• Press the Preset EQ button on main unit repeatedly to cycle through the following
equalization modes.
CLASSIC ROCK POP JAZZ PASS
DBBS
Press DBBS button to obtain the DBBS effect. And the display will show “BBS-ON” press this
button again the “DBBS” resume to the normal sound effect.
Random
In CD mode, press “Random “ button (ON REMOTE), the display will show “RNDM” and CD
disc will play in random sequence immediately. Press “Random” again, the “RNDM” mark will
disappear from display and CD disc will play in normal sequence. Press “Stop” button to stop
the CD.
SLEEP FUNCTION
You can set the unit to switch off after certain period of time as follows:
1. Press POWER to turn on the unit.
2. Press the SLEEP button. The display will show SLEEP and 90.
3. Keep pressing the SLEEP button to change the minute shown in display. You can set the unit
to switch off after 10-90 minutes.
4. Release the SLEEP button to take effect.
5. At any time, you can press SLEEP button the second time to cancel the sleep function.
LISTENING TO RADIO OPERATION
1. Press the POWER button to turn the unit ‘ON’.The STANDBY/ON indicator lights’OFF’.
2. Select the Tuner function by pressing the TUNER/BAND button.
3. Select the desired band (AM or FM) with the TUNER/BAND button.
4. Tune to the desired radio station by pressing the UP TUNING or DOWN TUNING buttons on
the unit or on the remote control.
5. If you hold the UP TUNING or DOWN TUNING button for more than half a second the Tuner
will begin to automatically scan until a strong signal is found.
6. To turn off the radio, press the POWER button to switch the unit into standby mode. The
STANDBY/ON indicator lights ‘RED’.
STORING PRESET STATIONS
1. Tuner either automatically or manually (as described in steps 4
or 5 above) to the station to be stored.
2. Press the PROGRAM(Memory)/CLOCK button once.
Channel number will flash in the display and “PRG” will display
5 seconds. During this time you must select the desired
memory location by pressing the MEM.CH + button.
3. Press the PROGRAM(Memory) Button again to store the
station at that location.
4. The unit can store up to 30 FM stations, 10 AM stations.
5. To recall the stored stations from the memory, press +
MEM.CH – button.
GB 6 1 GB 64
OPERATING INSTRUCTIONS
1. Mute Button
2. Aux Button
3. FM/MW Button
4. Preset Down Album/MEM.CH Button
5. CD Play/Pause Button
6. Skip Down/Search Backward Button
7. CD Stop Button
8. Random Button
9. Sleep Button
10. Timer Button
11. Standby/On Button
12. Mode/Find (ESP/ID3/FIND/ST) Button
13. Volume Down Button
14. Preset Up Album/Mem.Ch Button
15. Skip Up/Search Forward Button
16. Volume Up Button
17. Intro <CD MODE> Button
18. Repeat Button
19. PROG/MEM/CLK
20. EQ (Pass, Classic, Rock,
Pop, Jazz mode Preset
Equalizer in cycilc order) Button
21. Function Button
22. DBBS Button
/FIND
BATTERY INSTALLATION
Insert (lithium CR 2025) batteries into the battery compartment of the remote controller and
close the cover.
BATTERY REPLACEMENT
When the batteries become too weak, the operating distance of the remote controller is
greatly reduced and you will need to replace the batteries.
NOTES:
• To maintain the accuracy and long life of the transmitter, do not press two or more
buttons simultaneously.
• If the remote control is not to be used for a long time, remove the batteries to prevent
possible damage through leaking batteries.
USING THE REMOTE CONTROLLER CORRECTLY
• Point the remote controller at the Remote Sensor.
• The functions of the buttons on the remote control are the same as the corresponding
controls on the main unit.
• When there is a strong ambient light source, the performance of the infrared Remote
Sensor may be degraded, causing unreliable operation.
• The maximum effective distance for remote control operation is about 15 feet.
REMOTE CONTROLS
FM/MW PROG/MEM/CLK