3
Rear Guard Assembly
Pull out the fan body from the box. Remove the plastic
guard nut from the motor shaft. Then insert the rear guard
into the front side of the motor shaft. Make sure that the
central holes on the guard must fit the plastic pins around
the shaft. Insert the guard nut and rotate it clockwise to
lock the rear guard. (As shown in Fig.1)
Fan Blade Assembly
Insert the blade into the motor shaft. Make sure that the
stopper pin is clipped into the groove of the blade. Then,
insert the blade nut onto the blade center and rotate it
anti clockwise to tighten the blade. (As shown in Fig.2)
Front Guard Assembly
Cover the front guard onto the rear guard by slipping the
edge of the front guard into the other slot of the guard ring.
Then tighten the bolt in the joint of the guard ring by
screwdriver. (As shown in Fig.3)
Adjust the fan head to the desired angle by holding the
fan head and pushing the fan guard upward and
downward position.
Speed is controlled by pressing the key.
ASSEMBLY AND OPERATION
