After Sales Support
(AU) 1300 886 649 (NZ) 0800 836 761 | [email protected]
7
Getting Started
Unpacking
• Unpacking:
This product has been packaged to protect it against transportation
damage. Remove all packaging materials from around and inside the appliance,
including any foam pads and tapes. Tear the protective film (if any) off the lid and cabinet.
• Packaging materials:
Keep the original packaging carton and materials in a safe
place. It will help prevent any damage if the product needs to be transported in the
future, and you can use it to store the appliance when it is not in use. In the event that
the carton is to be disposed of, please recycle all packaging materials where possible.
Plastic wrapping can be a suffocation hazard for babies and young children, so
ensure all packaging materials are out of their reach and disposed of safely.
• Parts:
Check to ensure you have all the parts pictured opposite.
• Damage:
When unpacking, check the appliance carefully for damage. If it is
damaged, do not install the appliance. Contact our after sales support centre for
advice on examination or return of the damaged appliance.
• Power cord:
Unwind the power cord to its full length and inspect it for damage.
Do not use the appliance if the appliance or its cord have been damaged or are not
working properly. In case of damage, contact our after sales support line for advice
on examination, repair or return of the damaged product.
• Read the manual:
Before installing your new freezer, read all safety instructions,
especially the sections on installation and electrical safety. Then follow the installation
instructions below and on the next page.
• Clean:
Make sure the freezer is disconnected from the power supply before wiping
the interior surfaces and accessories with a damp cloth, moistened in lukewarm water
with a mild detergent. This will remove any dust from transit and storage and help
remove the typical smell of a brand new product. Then dry thoroughly.
CAUTION:
Do not use harsh or abrasive detergents or powders as these will damage
the finish.
Installation
• Clearances:
Ensure that air can circulate freely
around the back of the cabinet, which is necessary
to cool the compressor and condenser. Allow at
least 10cm clear space at the back and sides of the
unit, and 70cm above (Fig. 1).
• Overhanging wall units:
Ideally, the appliance
should not be positioned below overhanging wall
units. However, if it must be positioned below an
overhanging wall unit, the distance between the
top of the cabinet and the wall unit must be at least
1m so that you can comfortably open the lid and
access the contents.
Fig. 1
≥70cm
≥10cm
≥10cm
