4
L (WHITE)
LINE OUT
R (RED)
ANTENNA
CONNECTOR
ISO CONNECTOR
B
A
1 3 5 7
2 4 6 8
5 7
4
8
BLUETOOTH ANTENNA
CONNECT TO
EXTERNAL MICROPHONE
TALK
Notes:
• Do not press the front panel hard against the unit when attaching it. It can be easily attached by pressing it lightly
against the unit.
• When you carry the front panel with you, put it in the supplied front panel case.
• Do not press hard or give excessive pressure to the display window of the front panel when attaching it to the unit.
CLEANING THE CONNECTOR
The unit may not function properly if the connectors between the unit and
the front panel are contaminated with dirt. In order to prevent this from
happening, detach the front panel by pressing the
button and clean
the connector from time to time.
Clean the connector with a cotton swab together with contact cleaner as
illustrated. Be sure to clean them carefully pin by pin and make sure not
to damage the connecting points.
WIRE CONNECTION
RCA Jack Line Out:
White (left) Red (right)
External Microphone:
Black
CONNECTOR A
4. 12V
5. AUTO ANTENNA OUTPUT
7. +12V (TO IGNITION KEY)
8. GROUND
Note:
(connector A no. 7) must be connected by car ignition key in order to avoid
that car battery being drained when the car will be not used for long period.
CONNECTOR B
1. REAR RIGHT SPEAKER (+)
2. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
Maintenance
FUSE REPLACEMENT
If the fuse blows, check the power connection and replace the fuse. If the fuse blows again after the replacement, there
may be an internal malfunction. In this case, consult your nearest repairing center.
Warning
Use the specified amperage fuse for each lead. Use of a higher amperage fuse may cause serious damage.
OPERATING INSTRUCTIONS
1.
POWER ON/OFF
By pressing this key, the unit is switched on or off. This unit is turned on by pressing any key.
2.
SELECT
3.
VOLUME UP/DOWN
Turning the VOL knob Right or Left (3), you can adjust VOL/BASS/TREB/BAL/FAD. To select other functions, press the SEL (2)
button shortly until the desired functions is shown on the display. Figure 1 shows how control functions are selected using the
SEL button.
1
3
2
4
2
5
2
6
2
2
Fig. 1 Selection of sound control functions
1. VOL 2. SEL 3. BAS 4. TRE 5. BAL 6. FAD
Turning the VOL knob Right or Left. Increase or decrease the volume by turning
VOL
VOL
or
VOL
VOL
. These buttons can be used to adjust
the BASS, TREBLE, BALANCE and FADER.
Note:
When you press and hold “SEL” key longer than 2 sec, unit enters FUNCTION select mode. In order to exit such mode,
simply press “DISP” key or just wait around for 8 sec. and unit automatically exits.
IN VOL
SEL
2 sec.
SEL
ADJ
SEL
TA VOL
SEL
EON
SEL
DSP
Cotton Swab
Rear of
front panel
Main unit