
4.3 SMPS
6 Pin, Data Connector Pin Assignments
PIN
1
2
3
4
5
6
NAME
REM
DATA
CLK
STB
GND
VCC
I/O
I
I
O
O
O
DESCRIPTION
Front Panel Data input
IR sensor interrupt
Front Panel chip select
Front Panel clock
Front Panel Data output
The mains power(220VAC) fed from N1 is filtered through C1, L1, C2 and L2 then rectified by D1, D2, D3 and D4
and generates an output at 300VDC. This 300VDC fed to T1 (pin2, pin4) which connects to TEA1523P(pin2), then
TEA1523P will automatically generate a 50KHz square waveform, this 50KHz square waveform controls the
ON/OFF between TEA1523P pin2 and the ground. In normal condition, T1 primary (between pin2 and pin4) will
create a 50KHz square waveform which is controlled by TEA1523P, this signal then fed to T1 and generates 2
different potential voltages of 12V and 5V between pin17, pin14 and pin16, pin14 respectively. The 12VDC and
5VDC then rectified by D7, D8, D9 and then filtered by L3, L4, L5, C9, C10 and C11. The feedback voltage is
controlled by Ic3 TL431 and IC2 PC817. When the output voltage is higher than 5V, the voltage at TL431(2.5V) is
compared with R10 and send out a signal to 5L0380R, the output square waveform then will change to adjust the
output voltage, this acts as a voltage stabilizer.
4.2.1 Front Panel Interface
15
DVD Service Manual
Содержание A-211
