HA5-Fiber HDMI to 3G-SDI over Fiber v1.2 5
www.aja.com
I/O Connections
Figure 2. HA5-Fiber Mini-Converter
USB
Port
ST Fiber Output
Signal
Presence
Lock LED
2 Channel
Unbalanced
Analog Audio
In (RCA Jacks)
DC
Power
Input
Power
LED
HDMI
Input
Connector
NOTE: The LOCK LED indicates valid input video by color. Off is no signal, green is SD, red
is HD.
User Controls
Mini-Config Control
Automatic input format detection configures the unit automatically to match
input and output video parameters. In most cases, manual configuration is not
necessary. Advanced Mini-Config control supports color space and bit depth
adjustments, and audio channel selection.
Configuration set via Mini-Config is stored in the HA5-Fiber unit through
subsequent power cycles.
Installation
Typically, HA5-Fiber installation consists of the following steps:
1. Ensure the converter is disconnected from power.
2. Connect equipment to the converter HDMI input connector, the 3G, HD-SDI
or SD-SDI over Fiber ST output connector, and the analog audio inputs (if
used).
3. Connect audio equipment to RCA connectors (optional)
4. Apply power to the converter (AJA power supply included).
5. The converter will now run using the default factory settings. If you wish to
alter the factory settings, you’ll need to:
• Install the AJA Mini-Config software on your computer
• Attach the converter via USB
• Make your changes using Mini-Config setup screens.
• This process is detailed in "Chapter 2 Operation" on page 7.
