5
En
1
Connect the speaker cords to the front speakers,
surround speakers and center speaker.
For the front speakers (marked "FRONT"), connect the ends
of the stripe cords to the
0
terminal and the ends of the
other cords to the
9
terminal with the front speakers
cords (without a plug, approx. 4 m / 13.1 ft. ).
For the surround speakers (marked "REAR"), connect the
ends of the stripe cords to the
0
terminal and the ends
of the other cords to the
9
terminal with the surround
speaker cords (with plugs, approx. 8 m /26.2 ft.).
For the center speaker (marked "CENTER"), connect the
end of the stripe cord to the
0
terminal and the end of
the other cord to the
9
terminal with the center speaker
cord (with a plug, approx. 3 m / 9.8 ft.).
2
Connect the front speakers.
Connect the right front speaker to the FRONT SPEAKERS
R terminals and the left to the FRONT SPEAKERS L
terminals. The speaker cords with the white stripes go to
the
0
terminals.
3
Connect the surround speakers.
Connect each surround speaker cord to the SURROUND
SPEAKERS R jack or the SURROUND SPEAKERS L jack.
FM antenna
AM antenna
4
Connect the center speaker.
Connect the center speaker cord to the CENTER SPEAKER
jack.
5
Connect the subwoofer.
Connect the subwoofer cord to the SUB WOOFER jack.
•Refer to the Operating Instructions of TS-WM5 for the
details.
6
Connect the supplied antennas.
Connect the FM antenna to the FM 75
Ω
terminals and
the AM antenna to the AM LOOP terminals.
7
Connect the video equipment (DVD player, LD
player, video tape player, etc.).
If the video equipment has an OPTICAL OUT jack;
Remove the dust cap
a
from the DIGITAL IN (PCM/
DOLBY DIGITAL) OPTICAL (VIDEO) jack of this unit. Then,
connect the OPTICAL OUT jack to the DIGITAL IN (PCM/
DOLBY DIGITAL) OPTICAL (VIDEO) jack with an optional
optical connecting cord.
Tip:
To activate the spectrum analyzer, connect the digital
equipment also by analog connection to the VIDEO/AUX
jacks (see below).
