Aiwa XR-M700, Руководство по обслуживанию

Страница: 35 / 46

– 35 –
38 LVSS – Left channel one-bit D/A converter ground. Must be connected to 0V.
39 RVSS – Right channel one-bit D/A converter ground. Must be connected to 0V.
40 RCHO O Right channel one-bit D/A converter output.
41 RVDD – Right channel one-bit D/A converter power supply.
42 MUTER O Right channel one-bit D/A converter mute ouput. (Not used)
43 XVDD – Crystal oscillator power supply.
44 XOUT O
Connections for a 16.934MHz crystal oscillator element.
45 XIN I
46 XVSS – Crystal oscillator ground. Must be connected to 0V.
47 SBSY O Subcode block synchronization signal output. (Not used)
48 EFLG O C1, C2 single and double error correction monitor pin. (Not used)
49 PW O Subcode P, Q, R, S, T, U, V and W output. (Not used)
50 SFSY O
Subcode frame synchronization signal output. This signal falls when the subcode are in
the standby state. (Not used)
51 SBCK I
Subcode readout clock input. This is a Schmitt input.
(Must be connected to 0V when unused)
52 FSX O
Output for the 7.35 kHz synchronization signal divided from the crystal oscillator.
(Not used)
53 WRQ O Subcode Q output standby output.
54 RWC I Readwrite control input. This is a Schmitt input.
55 SQOUT O Subcode Q output.
56 COIN I Command input from the control microprocessor.
57 CQCK I
Input for both the command input acquisition clock and the SQOUT pin subcode
readout clock input. This is a Schmitt input.
58 RES I Chip reset pin. This pin must be set low briefly after power is first applied.
59 T11 O Test output. Leave open. (Normally outputs a low level). (Not used)
60 16M O 16.9344 MHz output. (Not used)
61 4.2M O 4.2336 MHz output.
62 T5 I Test input. A pull-down resistor is built in. Must be connected to 0V.
63 CS I
Chip select input. A pull-down resistor is built in. Must be connected to 0V if not
controlled.
64 T1 I Test input. No pull-down resistor. Must be connected to 0V.
Pin No. Pin Name I/O Description