– 2 –
When servicing and checking on the TV, note the followings.
NOTICES BEFORE REPAIRING
To make the best use of this equipment, make sure to
obey the following items when repairing (or mending).
1. Do not damage or melt the tunicate of the leading wire on
the AC1 side, including the power supply cord.
2. Do not soil or stain the letters on the spec. inscription plates,
notice labels, fuse labels, etc.
3. When repairing the part extracted from the conducted side
of the board pattern, fix it firmly with applying bond to the
pattern and the part.
4. Restore the following items after repairing.
1) Conditions of soldering of the wires (especially, the
distance on the AC1 side).
2) Conditions of wiring, bundling of wires, etc.
3) Types of the wries.
4) Attachment conditions of all types of the insulation.
5. After repairing, always measure the insulation resistance
and perform the voltage-withstand test (See Fig-1).
1) The insulation resistance must be 7.0 to 9.5 M
Ω
when
applying
500V
per second.
2) In the voltage withstand test, apply 3 kV for
1
or more
minutes
and check that the GO lamp lights.
*
Breaking current set to 6 mA.
*
Connect the safety checker as shown in Fig-1, then
measure the resistance and perform the test.
* Do not touch the equipment during testing.
*
For details of the safety checker, refer to the supplied
Operation manual.
and high voltage parts. Therefore, put these parts in the
original positions.
5. Take care of the cathode-ray tube.
By setting an explosion-proof cathode-ray tube in this
equipment, safety is secured against implosion.
However, when removing it or servicing from the back, it
gives out shock that is dangerous. Take enough care to deal
with it.
6. Avoid an X-ray.
Safety is secured against an X-ray by giving considerations
to the cathode-ray tube and the high voltage peripheral
circuit, etc. Therefore, when repairing the high voltage
peripheral circuit, use the designated parts and do not
change the circuit. Repairing, except indicates, causes
rising of high voltage, and the cathode-ray tube emits an
X-ray.
7. Perform a safety check after servicing.
Confirm that the screws, parts and wiring which were
removed in order to service are put in the original positions,
or whether there are deteriorated portions around the places
serviced.
Fig-1
Insulation resistance: 7.0 to 9.5 M
Ω
(500 V/s)
Voltage-withstand: 3 kV for
1
or more
minute
s
1. Keep the notices.
As for the places which need special attentions, they are
indicated with labels or seals on the cabinet, chassis and
parts. Make sure to keep the indications and notices in the
operation manual.
2. Avoid an electric shock.
There is a high voltage part inside. Avoid an electric shock
while the electric current is flowing.
3. Use the designated parts.
The parts in this equipment have the specific characteristics
of incombustibility and withstand voltage for safety.
Therefore, use a part which has the same character as the
replaced part. Especially as to the important parts for safety
which is indicated in the circuit diagram or the table of parts
with a mark, the designated parts must be used.
4. Put parts and wires in the original position after assembling
or wiring.
There are parts which use the insulation material such as a
tube or tape for safety, or which are assembled so that these
parts do not make contact with the printed board. The inside
wiring is designed not to get close to the pyrogenic parts
!
Safety checker (Model 7110, etc.)
Earth cable
AC cable
Connect the earth cable
to the outside metal part
terminal.
All manuals and user guides at all-guides.com
