www.aivonet.com
.
LED
Power
LINK/ACT
PoE
Status
On
On
Blinks
Off
On
Off
Color
Green
Green
-
-
Green
-
Description
The switch is supplied with suitable power
The port is connecting
The port is receiving or tranmitting data
The port is not linked successfully with the device
PD is connected
No PD is connected or power forwar ding fails
• RJ-45 Ports (Auto MDI/MDIX)
Auto-sensing ports of 10/100/1000 N-way for 10Base-T, 100Base-T, 1000Base-T
connections. [In general, MDI means connecting to another Hub or Switch while MDIX
means connecting to a workstation or PC. Therefore, Auto MDI/MDIX means that you
can connect to another Switch or workstation without changing pin-to-pin or
crossover cabling.] All of these ports can supply to PDs.
Hardware Description
• The Front Panel
• LED Indicators
Per Device: Power
Per Port: LINK/ACT (Link/Activity)
Per PoE Port: PoE
The front panel consists of LED Indications and 9 auto-sensing ports.
Figure 2. Front panel view of LED indications
www.aivonet.com
Network Application
Package Contents
• DC Power Connector
Plug the female connector into the switch and male connector into the power outlet.
Supports input voltages 44~57 VDC.
• PoE Switch
• DC Power adapter
• 4 Adhensive-backed rubber feet
• User’s manual
Package contents include the following:
*IMPORTANT: If any piece is missing or damaged, please contact your local dealer or reseller for service.
• The Rear Panel
The rear panel view of the PoE switch consists of a DC power connector
Figure 3. Rear panel view of the switch
The PoE switch is designed as a segment switch that has a large address table and high
performance to deal with interconnecting networking segments.
PC, workstations, and servers can communicate with each other by directly connecting with
the PoE switch. The switch automatically learns nodes addresses, which are subsequently
used to filter and forward all the traffic based on destination address.
The PoE Switch can provide power to PDs that follow the IEEE 802.3af/at standard in the
network. It solves the problem of the position limitation. For a better performance, the
network devices should be installed in an appropriate position. The following figure is an
example of network application for Power over Ethernet Swtich.
