Aitchison SEEDMATIC PROFESSIONAL 8140, Руководство пользователя

Страница: 28 / 61

28 | P a g e
•
Settings : Used to alter the settings of the tiles contained by the
cluster.
The hopper cluster tiles are used to set the application rate as
well as monitor: the perceived rate, the shaft speed and the area
covered by the hopper.
•
Rate : This shows the perceived application rate in the selected
units. The bar at the top shows the motor speed as a proportion
of the motors top speed. Adjust the ground speed (within
reason) to keep the motor comfortably within 5-90%. Change
the gearing and re-calibrate if required to maintain the set rate.
•
Shaft : This tile shows the shaft speed in RPM and is used to
detect drive chain faults. When the shaft speed doesn’t match
the expected shaft speed: the buzzer will start, a Warning
message will popup describing the potential fault and the tile will
change colour to a light red. The warning can be accessed
directly by tapping on the tile or through the warnings tab (See
Alerts ).
•
Fan : This tile shows the RPM of the hydraulic fan. If the Fan
speed is too high or too low during application, a warning will
pop up. The limits can be set in the clusters settings menu.
•
Area : This tile shows the total area covered by the hopper while
running. It is automatically cleared when a new job is started and
can be manually cleared using the cluster Menu.
•
Rate Controller and Enter : The rate controller tile is used to
select the applcation rate and the Enter button tile is used to
submit the changes. The rate can be changed and submitted at
any time. The rate can be changed by using the -/+ buttons or
using the popup keyboard by clicking on the number field.
Holding the + or - button will increment or decrement the rate
quickly. The number field background will be white when the
value matches the set rate and will change to yellow if it does
not match. To set the number field back to the set rate, click on
the units field below the number. The product name set during
calibration can be seen at the bottom of the Rate Controller tile
(See
Calibration ). There are two preset rates above the product
name. These can be loaded by clicking on them and set by long
pressing for 2-3 seconds. The bottom of the Rate Controller tile
shows the speed ground speed range to achieve the set rate. The
bar indicates the current speed in relation to these limits.