TRAMPOLINE AND ENCLOSURE ASSEMBLY
19. Connect lower pole(K) with
upper pole(J) until button lock
is locked in place. Do this for
all six enclosure poles.
WARNING:
2-3 adults in good physical condition are required for the following assembly. Wear proper
shoes and maintain balance to prevent a fall. Failure to follow all instructions and warnings exactly may
result in serious injury. Do not use your trampoline and/or enclosure until you have thoroughly read and
understand all instructions and warnings provided.
REFER TO PARTS LIST FOR IDENTIFICATION OF PARTS
20. Divide the six enclosure poles
around the trampoline and
place them near top rail(C) as
per the image above, after
which each of the enclosure
poles should be connected to
the steel rod circle at the top
of the enclosure net.
Top rail(C)
21. Enclosure poles are
connected to the steel rod
circle as per the image above.
22. Carefully place the enclosure
poles into the “T” connectors
on the top rail until all 6 poles
are fixed in place.
23. Find the enclosure entrance
and pull it firmly down. Then
align the zipper in between
two of the enclosure poles.
Locate the nearest metal “D”
ring which is stitched to the
jump mat. Start fastening the
enclosure to the jump mat by
threading the cord as shown
in step 24.
24. Tie one cord-end(L) to the
“D-ring” nearest to the
enclosure entrance and
thread the other end through
the nearest cord hole in the
bottom of the enclosure net.
Then continue to thread the
cord through each “D-ring”
and nearest cord holes in the
bottom of the net until the
enclosure has been fastened
to each of the “D-rings”
For enlarged view see point
25
