17
INSTALLATION
1) Ensure that power is disconnected from wheel.
2) Begin by positioning one empty segment bay at the
top of the wheel and opening the two retaining latches,
Figure 20
.
NOTE:
The face of the segment with the embedded stiffener
must face the motor side of the wheel,
Figure 22
.
3)From the pulley side, slide segment into place nose
first,
Figure 21
, then push outer portion of segment
in to wheel frame. If you are installing an ERC-81 or
ERC-86, use a 3/16-inch Allen wrench and the nose
bolt to secure the segment to the hub.
4) Close the retaining latches on outer corners of
segment to secure the segment inside the wheel,
Figure
20.
5) Rotate first segment 180-degrees and install the
opposing segment to re-balance the wheel,
Figure 19
.
6) Repeat until all of the remaining segments are
installed, ensuring balance throughout the procedure,
Figure 19
.
7) Apply power to wheel to confirm rotation.
Figure 22
Embedded stiffener faces motor side.
