Airxcel MAXXFAN MINI DELUXE 3805, Инструкции по установке, информация и руководство по эксплуатации, Страница: 3 / 8

INSTALLATION INSTRUCTIONS
WARNING!
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO
PERSONS, OBSERVE THE FOLLOWING:
Installation work and electrical wiring must be done by qualified persons(s) in accordance with
all applicable codes and standards, including fire-rated construction.
STEP 1
MAXXFAN MINI Deluxe VENTS require a
14” x 14” roof opening. If you are replacing
another type already installed, remove the
old existing roof vent. Remove all old roof
sealant for a
minimum of 2” entirely around
the roof opening.
STEP 2
Measure the thickness of the roof opening
and, if necessary, mark and cut the height of
the
MAXXFAN MINI Deluxe sleeve per the
following table. NOTE : for curved roofs
measure the thickest part of the roof.
VEHICLE
ROOF
THICKNESS
CUT FROM MAXXAIR
MINI VENT SLEEVE
4.0
– 4.5
inches
NONE (use full length
sleeve)
3.5
– 4.0
inches
0.5 inches
3.0
– 3.5
inches
1.0 inches
2.5
– 3.0
inches
1.5 inches
2.0
– 2.5
inches
2.0 inches
1.5
– 2.0
inches
2.5 inches
1.0
– 1.5
inches
Not Applicable, Sleeve
not used
STEP 3
Prior to installing the MAXXFAN MINI
Deluxe hood portion over the roof opening,
apply a continuous strip of BUTYL tape or
equivalent to the underside of the flange in
the area under the screw location dimples.
Attach the garnish sleeve using 4 screws
provided in the hardware kit.
CAUTION!
When installing your
MAXXFAN MINI Deluxe , only use a
caulking/sealant compatible with the
flange (plastic product) and the roof
surface. DO NOT use materials
containing solvents such as or similar to
Xylene, Toluene, Methyl Ethyl Ketone
(MEK), Acetate or Acetone as they can
damage the flange. Also, Polysulfide
(Thiokol) type sealants must be avoided.
If in doubt, please contact the
manufacturer of your RV.
STEP 4
Insert the MAXXFAN MINI Deluxe hood into
the roof opening with the louvered section
facing the rear of the vehicle and centering
the hood in the opening. Using the twenty-
eight (28) screws provided, attach the flange
to the roof at each dimple location along the
flange. Screw into the dimple to pierce the