Airwell YUDA060, Руководство по обслуживанию

Страница: 29 / 70

As for outdoor unit circuit, please see Installation Manual of outdoor unit.
Note: All electric wires have their own poles, poles must match that on terminal block.
Installation of ornament panel
1. Prepare ornament panel Handling of ornament panel
Ornament panel shall not be placed face down or against wall,
neither on an uneven object.
Don' t bend carelessly the swing flap, or, problem may occur.
(1) Remove air inlet grill from ornament panel:
Push in the bar on inlet grill and lift it up. (Refer to Fig. 1)
Lift it up for about 45 degree and remove it from ornament. Tear off adhesive
tape fixing air filter on the back of the air inlet grill. (Refer to Fig. 2)
Be sure to show customers Operation Manual and guide them how to operate unit
correctly. Before installation. read also the Installation Manual of indoor unit.
With this ornament , 2 or 3 air flow direction is not available.
Suitable height is 3 m.
2
(2) Remove cover plate at corner
Tear off the adhesive tape, and slide it off. (Refer to Fig. 3)
Wiring example
Cautions for the installation
Accessory Pad
Bar
Fig. 1
Obscrve the following when connecting power supply
terminal block:
Don't connect wires of different specifications to the same
terminal block.
(Loose wire may cause overheating of circuit)
Connect wires of same specifications as shown in right Fig.
Connect wires of the
same specifications
at two sides.
Don't connect wires of
the same specifications
at one side.
Don't connect wires
of the different
specifications.
<<
WARNING >>
Pad
45
Fig. 2
Adbesive tape
2. Mounting on high ceiling
(1) Ornament panel can be mounted on ceiling as high as 3 m.
(2) Please install pad as accessary.
Cut open the pad along cutting ling. Use part a only and discard part b . (Refer to Fig. 4)
Install part a of the pad on the place shown in Fig. 5. Refer to Fig. 6.
Cutting line
a
b
Place it on the frame.
Leave no space.
Fig. 6
Fig. 4
Terminal block
Cover of control box(1)
Rubber tube A
Grounding lead
Cover of control box(2)
Out In
Field wiring
Attach seal pad
Don't fail to seal it, or water may come in.
Rubber
tube
Note: Have it sealed, leaving no space.
Seal pad (small size )
(Wind around wire)
12
1
Slide
Fig. 3
1
2
Installation
29