Airwell ST-NDHP 24R, Инструкция по эксплуатации

Страница: 11 / 36

11
Using the Wireless Remote Control Unit
Slide switch This is used to set the operation mode of the indoor units and to set the flaps.
•
Depending on the indoor unit used, the operation display and airflow
direction display settings will differ as shown below.
• Use a pointed implement to change the switch position.
• When the switch position has been changed, press the ACL button.
* For details on the flap functions, refer to the operating instructions of the
indoor unit used.
• Before use, check that the slide switch has been set to the position shown
in the figure above. For details on how to set the slide switch, consult your
dealer.
How to install batteries
1. Slide the cover in the direction indicated by
the arrow and remove it.
2. Install two AAA alkaline batteries. Make
sure the batteries point in the direction
marked in the battery compartment.
3. Use a pointed implement to press the ACL
button.
• The batteries last about a year, depending
on how much you use the wireless remote
control unit. Replace the batteries when the
wireless remote control unit’s display fails to
light, or when the remote control cannot be
used to change the air conditioner’s
settings.
• When the batteries are to be replaced, make sure that both batteries are
new and that the same kind of battery is used.
• Remove the batteries if the wireless remote control unit is not going to be
used for a prolonged period.
• Dispose of the used batteries at the designated location.
Model which supports
different flap settings
Swing-only model No-flap model
Slide switch position
Flap display on wireless
remote control unit
With the battery cover
removed
Heat pump (with auto
cooling/heating
function)
Heat pump (without
auto cooling/heating
function)
Cooling only
Operation mode display
on wireless remote
control unit
Slide switch position
ACL
button
Cover
OI-824-11-EG
01_Airwell_ST-NKFL7R_EN.fm Page 11 Thursday, June 15, 2006 4:18 PM