13
Airwallet PRO310
Installation Guide
The types of busy signal signal
1. First, connect the appropriate wires you want to use:
a. Connect ACL and ACN from the Airwallet PRO to the
neutral and line of the machine. These ports are often
located near the payment ports or can be found at the
machine’s power supply. The Airwallet PRO can also be
supplied with 24VDC. To do this move wire no. 1 & 2 to
terminals 5 and 8 inside the Airwallet PRO.
If the machine is installed with AC busy signal it must be
line. Is the busy signal neutral and can’t be modified to line,
then switch line/neutral power supply to the Airwallet PRO.
b. Check the wiring diagram and decide which start signal
the machine need. Supply this start signal to wire no.
3, when the Airwallet PRO receives the start signal, the
device will output this signal on wire no. 4, which is the
start signal. Connect the start signal wire from the
Busy signal type
High in use
Voltage when the machine is running - no voltage when the machine
is finished.
Low in use
No voltage when the machine is running - voltage when the machine
is finished.
End of cycle
Voltage sent as a minimum 1.000 ms. pulse when the program is
finished.
None
No busy signal is selected. The machine will be occupied for 5 min.
and then become available again.
