Step 4:
Route the large transaxle control cable up the handle
and connect the cable section with two (2) nuts to the the
bracket on the left side of the tug handle. Separate the nuts
equal distance to fit in place on the bracket and tighten the
nuts securely in place. Install the quick-connect fitting at the
top of the cable to the ball on the left side of the twist grip
handle. It is spring loaded and will hold securely in place.
Using the zip ties provided, secure the cable to the handle.
Step 5:
Lead the wires from the end of the tug handle through
the hole on the right side of the tug frame just behind the
solenoid and install the rubber grommet in the hole of the tug
frame. Take care not to damage the wires or the grommet when
inserting the grommet into the hole in the tug frame. Use a tool
with a very dull edge to help seat the grommet. It takes a little
patients to install this part. Connect the red wire ring terminal to
the solenoid terminal marked with red tape and connect the
other wire (green) ring terminal to the solenoid terminal marked
with green tape. Tighten the nuts securely.
Step 6:
Prior to the first use,
plug the charger cable into a 110V
outlet or extension cord and charge the batteries fully as
indicated by the green light at the top of the charger. The
orange light indicates batteries are charging. Keep the battery
charger plugged in between use. See the battery charger
manual for more information.
Final Step:
Install the protective battery and motor cover and
secure to the tug frame using the (4) 5/16 bolts, washers and
nuts.
Airtug® / 1350 Chester Industrial Parkway, Avon OH 44011 / 216-941-9781 / www.airtug.com
4
