AirTek Twister CP Gold, Руководство пользователя

Страница: 5 / 16

5
http://www.jperkinsdistribution.co.uk http://www.modelengines.com.au
Twister CP Gold
FINAL FLIGHT PREPARATION
4. INSTALLING THE BATTERY.
•
Secure the battery to the mounting tray
with the Velcro strap provided. See below:
5. ROTOR BLADES CHECK.
•
Unfold the main rotor blades to the flying
position as shown below.
•
Check the rotor blade bolt tension. Blades
should move with slight pressure applied.
6. LINKAGE CHECK.
•
Check that all linkages and connectors are
attached and that rotating parts rotate
smoothly.
•
Make sure that all linkages move freely
with no binding or tightness. Free up any
linkages that feel too tight.
7. SWITCH ON TRANSMITTER.
•
The Twister CP Gold is available with
either a Mode 1 or Mode 2 transmitter.
The Twister RC Radio Instruction
manual shows the layout of both
transmitter types.
•
Move the throttle stick and throttle trim to
the lowest (low throttle position) position.
•
Centre the trim levers on the other 3
functions.
LITHIUM POLYMER BATTERY
SAFETY
Before Charging Li-Po Batteries
•
Before charging your battery, check for any
visible damage e.g. check if the battery has
expanded or swollen in size or if the cells
have been punctured.
•
If any of the above is true: DO NOT
CHARGE THE BATTERY!
Charging Li-Po Batteries
•
ONLY use a charger designed to charge
Lithium Polymer batteries.
NEVER use
any other type of charger.
•
Never charge a hot battery.
•
Always allow battery to cool after flying be-
fore recharging.
•
Never attempt to charge at a faster rate
than recommended in the instructions.
•
Check the battery cell count matches the
charger cell count switch (if fitted)
•
Never charge unattended. Always stay with
the battery whilst charging in case of over-
heating and risk of fire.
•
Only charge on non-flammable surfaces
e.g. concrete floor (outside) or pyrex or
ceramic container.
NEVER charge inside
a car!
•
Stop charging immediately should battery
become hot to touch during charging.
•
In the event of a fire, use sand to extin-
guish the flames.
DO NOT USE WATER
Using Li-Po Batteries
•
Do not modify or change any part of the
battery or lead.
•
Do not remove the heat shrink covering
•
Any modification may damage the battery
and invalidate any warranty claim.
•
Do not place battery near fires or any high
temperature object or device.
•
Do not charge batteries whilst driving.
•
Do not store batteries in a motor vehicle.
•
Do not allow batteries to get wet or sub-
merged in any liquid.
•
Do not short circuit batteries.
•
Should skin or eyes come in contact with
the electrolyte, rinse thoroughly with water
and seek Medical assistance.