9
PROBLEM POSSIBLE
CORRECTION
Excessive tank pressure.
Move the Auto-On/Off lever to the Off position. If the unit doesn’t shut off,
unplug it from the power source and contact Midwest Air Technologies.
Motor will not start.
Make sure power cord is plugged in and the switch is on. Check the reset button
(if equipped) on the motor. Reset if needed or allow 30 minutes for cooling period.
Inspect for the proper size fuse in your circuit box. If the fuse was tripped, reset it
and restart the unit. If repeated tripping occurs, replace the check valve or contact
Midwest Air Technologies.
Excessive moisture in the
Remove the water in the tank by draining after each use. High humidity
discharge air.
environments will cause excessive condensation. Utilize water filters on your air
line.
Water condensation is not caused by compressor malfunction. Be sure the
compressor’s air output is greater than your tool’s air consumption rate.
Air leaks from the tank body
Never drill into, weld or otherwise modify the air tank or it will weaken. The tank can
or tank welds.
rupture or explode. Contact Midwest Air Technologies.
CAUTION
