5-3
Wet Bath Shower Stall
To clean your fiberglass shower stall unit, use warm water
and one of the stronger liquid detergents. Do not use abrasive
cleaners as they may scratch and dull the surface of your
unit. Stubborn stains can be removed with solvents such as
turpentine or paint thinner. Restore dulled areas by rubbing with
an automotive type liquid cleaner, then, put the soft glow back
into your unit with a light application of liquid wax.
CAUTION
Applying wax to the base of the shower floor is
not recommended, as this could create an unsafe
surface.
Dinette
On one of two models, the U-shape dinette converts to a bed.
Lift the tabletop off the table support post. Remove post and
store in wardrobe closet. Drop tabletop between benches and
move seat backrests from the perimeter walls onto the table area
to complete the conversion. Reverse this process to re-assemble
the dinette table.
Lighting and Switches
Nest features a variety of lighting options inside
and outside of the cabin. Lighting over the
lounge, galley, side-mounted sofa or pantry,
wardrobe and under-bed storage are switched at
the fixture. Lighting for the all other light sources
are controlled by wall-mounted switches.
The water pump is powered by a switch on the SeeLevel II
monitor panel, the water heater is powered by a switch in the
control panel area under the refrigerator, and the A/C unit and
furnace are both controlled by the thermostat.
Magic Light Operating Instructions
Additional information is located in your Owner’s Packet.
• The Magic Light Switch is located on wall opposite of galley.
• To turn the Magic Light on/off press the power button on the
wall switch. The power button will illuminate blue when the
power is off.
• To dim or brighten the Magic Light press the up or down button
on the wall switch.
• All other features are controlled with the app available on both
Android or IOS platforms.
1. Download App:
Search “Magic Light-BLE” in the App
store or “Magic LED Light V2” in the Google Play Store
and click install. Depending on your operating system,
Android or IOS, your screen layout may differ slight
from the following screenshots.
NOTE
The battery disconnect must be on for power to
the wall switch. The power button on the wall
switch must be on for functions to operate within
the magic light app.
2. Open App:
Turn on the Bluetooth on your phone or
tablet and open the app.
3. Find Device:
Once you open the app it should
automatically connect to the bluetooth controller.
If it does not connect right away you may need to
turn power off to the wall switch and turn it back on.
Clicking on the question mark in the upper left will take
you to a help screen.
Содержание (nest) 2019
