Airstream GLOBETROTTER 2023, Руководство пользователя

Страница: 44 / 104

5-16
2023 Globetrotter
Interior
Furnace
The manufacturer of the furnace in your trailer has
been well known in the RV industry for many years�
The furnace burns LP gas, and is powered by 12-volt
current from the batteries or power converter when
plugged in to city power� Operating instructions are
located in your owner’s packet� If they should become
misplaced, new literature can be ordered directly
from the manufacturer or your Airstream dealer� The
manufacturer also offers a detailed service guide for
your furnace�
WARNING
Carefully read all the manufacturer’s instructions
prior to operating. NEVER store flammable material
next to the furnace or in close proximity to the
furnace exhaust outlet on the side if the trailer.
NOTE
If warranty service is required, use only a
service location recommended by the furnace
manufacturer or your Airstream dealer.
Microwave Ovens
Refer to the Certified Performance Checkout sheet,
included in your owner’s packet, for manufacturer,
model, and serial number information�
Monitor Panel
The display is the only system component that is
accessed by the user� All user input to the display is
done using the buttons along the bottom of the display�
The display receives the information from the three
sender pads via a single, two-conductor wire, and
displays the level information in percent of full on a
three-digit, LED display� When the front panel button
for a particular tank is pressed, the display powers
up and displays the level for that tank� If the button
is pressed and released, the display will show the
level for about 5 seconds and then shuts down
automatically� If another button is pressed before the
Exhaust Vent
Operation
The bath exhaust vent (shown above) removes
moisture from the air when using the shower� To
operate, you first need to open the vent.
To open the vent, push the button on the handle to
disengage the clip and slide the handle upward until
the clip engages� Once open, turn the fan on by
pressing the ON/OFF button�
Turn the fan off before closing the vent�
To close the vent, push the button on the handle to
disengage the clip and pull the handle down until the
clip engages in the lowered position�
CAUTION
Turn off the fan before closing the vent. Damage
to the motor can occur if the fan runs with the vent
closed.
Cleaning Instructions
To clean the screen, make sure the fan is off� Remove
the four (4) screws� Clean with mild soap and water
only�
CAUTION
Do not operate the fan with the screen removed as
this could result in damage or injury.
Fuse
To change the 5 Amp fuse:
1� Make sure the fan is off�
2� Remove the cap by turning it to the left to gain
access�
3� Replace with a type GMA 5A fast-acting fuse�
4� Replace the cap to secure the fuse in the holder�