Airstream FLYING CLOUD 2023, Руководство пользователя

Страница: 47 / 112

Interior
2023 Flying Cloud
5-17
Solar System
If equipped, the rooftop solar panels installed on
your Airstream help maintain battery health, reduce
operating expenses, and extend the battery life of the
batteries� The solar system’s solar charge controller
gathers energy from the individual solar panels and
stores it in your batteries� The system features a
display (shown above) that allows you to view live
status information like solar watts and battery voltage�
To optimize solar charging, ensure the panels are
clean and not shaded by trees or structures that might
block the sun� Please refer to your owner’s packet for
reference material that discusses the solar system and
its operation�
The charge controller is configured for a three-step
charging process:
1� Bulk - The controller delivers as much charge
current as possible to quickly recharge the
batteries�
2� Absorption - The controller switches to a constant
voltage mode�
3� Float - Voltage is applied to the batteries to
maintain them in a fully charged state�
Airstreams manufactured without the solar option have
been pre-wired to support solar panels� These units
will have a 3-port rooftop-mounted plug-in that allows
installing rooftop solar panels without running wires�
In addition, a quick plug-in port suitable for a portable
solar charging kit has been pre-wired at the front of the
unit, near the battery box
Refer to Section 8 - Maintenance for Solar Panel
Wiring diagram and information�
Thermostat
To turn thermostat on when the black light is off, press
any button to “wake up” the thermostat. Press and
release the - ON/OFF button�
Pressing the MODE button will cycle through the
mode options available� A mode is an operation that
can be performed by the unit and is controlled by the
thermostat� The available modes typically are: OFF,
COOL, HP (Heat Pump), FURN (Furnace), and AUTO�
Press the F/C button to switch between Fahrenheit and
Celsius�
NOTE
The Heat Pump Operation works well only when
the ambient temperature is above 45° F/ 7°C
The FAN button us used to select the fan speed� The
options are: AUTO, HI, MED, or LOW�
NOTE
When using the FURNACE the fan speed should
be set on AUTO. Otherwise the AC fan will
continuously run.
To set the Clock to the correct time, press the CLOCK
button. The “HOUR” digits will flash first. Use the UP/
DOWN arrows to adjust. Press the CLOCK button
again and the “MINUTE” digits will flash. By pressing
it a third time the “AM/PM” icon will flash. Press the
CLOCK button again will store these settings into
memory�
To Do a System Reset/Remove Error Code:
• Make sure the CCC 2 thermostat is in the OFF mode
(either a blank screen or clock only showing)
• Simultaneously press the MODE and ZONE buttons�
The LCD will display “IniT” and all available zones.
• Release the MODE and ZONE buttons�
• Press the ON/OFF button to exit system set up� This
will remove any error code, reset the system, and
allow you to re program the thermostat�