Airstream A-Series 2006, Руководство пользователя

Страница: 46 / 85

F
INTERIOR
F - 2
TABLE AND COUNTER CARE
The table tops and counter areas are made from Corian. Most dirt and residue can be
removed by using soapy water or an ammonia-based cleaner, rinsing and wiping dry.
For difficult residue, spray residue with Cleaner for DuPont Corian® from Stone Care
International, wait for about 30 seconds for cleaner to work. Wipe dry with a paper
towel. If residue persists, repeat process.
For occasional disinfecting, wipe surface with dilute household bleach (1 part water/1
part bleach). Rinse top thoroughly with water and wipe dry. Over the counter cleaners,
such as, Clean EnCounters® may be used for routine cleaning in place of soap and
water.
To enhance the gloss level on semi-gloss and high-gloss finishes, use a countertop
polish such as Countertop Magic®1, Hope’s Countertop Polish®2 or Enhance Coun-
tertop Polish®.
Corian® is an excellent material for heat resistance. As with all countertop materials,
it is important to minimize direct heat exposure to protect your surface and invest-
ment. We recommend using heat trivets or hot pads when placing hot objects on any
surface. Allow cookware to cool before placing them into a Corian® sink.
In most cases Corian® can be repaired if accidentally damaged.
• Avoid exposing Corian® to strong chemicals, such as paint removers & oven clean-
ers. If contact occurs, quickly flush the surface with water.
• Do not cut directly on Corian® countertops.
TILE COUNTER TOPS
Protect against chipping, scratches, especially on glazed tiles.
Avoid hard blows which can chip the tile.
Tile Counter Cleaning
Wash with detergent solution, and rinse. To clean dingy grout, occasionally apply a so-
lution of chlorine bleach and water to stand not more than 5 minutes; rinse thoroughly
and wipe dry. General-purpose household cleaners may also be used if label says can
be used on ceramic tile; follow directions exactly. NEVER use scouring powders or
other abrasives as they will scratch the finish.
Creamy liquid appliance wax can be used, if wished, for further protection of tile and
grout.
DRAWERS
Drawer removal - pull drawer out to stop then raise front of drawer to clear rollers.
SHOWER STALL
To clean your ULTRA/GLAS shower stall unit, use warm water and one of the stronger
liquid detergents. Do not use abrasive cleaners; they may scratch and dull the surface
of your ULTRA/GLAS unit. Stubborn stains can be removed with solvents such as
turpentine, paint thinner or acetone. Restore dulled areas by rubbing with an automo-
tive-type liquid cleaner, and then put the soft glow back into your ULTRA/GLAS unit
with a light application of liquid wax.
WARNING
: Do not wax the floor of the stall without using a bath mat
afterward to prevent a dangerous slippery floor condition.
INTERIOR METAL SKIN