Page 1 of 8
70
– A Aleph Dr.
Newark, DE 19702
Support Email:
Toll Free Number: 1-800-AIRSLED (1-800-247-7533)
SAFETY INSTRUCTIONS FOR USE
•
Airsled systems can move countless objects provided that the appropriate conditions exist and that
the load’s weight is within the system’s maximum lifting capacity. These conditions include the
following:
✓
Surface is level and free of incline and/or decline. DO NOT attempt using your Airsled system on
inclines, declines, ramps or stairs.
✓
Surface is smooth and non-porous and free of debris. Porous surfaces such as carpeting requires
use of Airsled’s Rough Surface Adapters (RSAs).
✓
Load’s weight is evenly distributed. If not the case, the air beams may need to be positioned in a
manner to help offset the uneven weight distribution (e.g., closer to the heavier side of the load).
✓
Lower center of gravity is better. Attempting to move an object with a high center of gravity may
result in undesirable tilting when lifted leading to a tipping hazard. If moving an object with a high
center of gravity, ensure adequate support is present to offset any tilting.
•
Keep all parts of the body, especially hands and feet, away from underneath the air beams and the
load being lifted while operating your Airsled.
•
DO NOT stand or ride on the air beams.
•
To avoid electric shock, do not use in damp or wet locations. Do not expose the blower to water or
other liquids. Use only grounded power cords and outlets.
AIRSLED VENDING MOVER COMPONENTS
BEFORE USING THE AIRSLED VENDING MOVER
•
Remove objects from the top and inside of the load you plan to move to prevent damage.
•
Shut OFF or disconnect any gas, electric of water that may be connected to the load.
•
Nonstructural features prone to bending
near the load’s base such grill covers should be removed; the
air beams should only make contact with
the load’s structural frame during movement.
•
Verify that no other features or fixtures (e.g., hoses, drip pan, connectors, flanges) hang down from the
load’s base that may prevent the air beams from making contact directly with the structural frame.
•
Because an Airsled will elevate the load, measure the overhead clearance between the highest point
of the load and any overhead objects such as cabinets. If less than
2”, please see the
Control and
Maneuverability
section.
•
If your model has Dual Speed (DS) performance, you will be able to operate the unit at full (HI)
strength or half (LO) strength. Operating at half (LO) strength reduced lifting power by 50% which
may be beneficial in tight, overhead clearance situations.
Qty
Description
2
Aluminum air beams
*
1
Blower (may/may not have variable speed and/or vacuum capability
depending on model)
1
Shoulder strap
5
Vacuum cleaner nozzles and attachments for models with vacuum
capability
1
Tee connector
2
Supply hoses that connect to the air beams
1
Lead hose that connects to the blower
4
Rough Surface Adapters (RSAs)
4
Spacer sticks
1
Foot brace
1
Carrying bag for your complete system
Please see Exhibit 1 for
a detailed system
diagram to order
replacement parts.
