AirSep Topaz, Инструкция по эксплуатации

Страница: 20 / 94

AirSep
®
Corporation
5-2 Topaz/Topaz+/Topaz Ultra Instruction Manual
8) Locate the plastic bag that contains the instruction manual, extra
gross particle filter, and a barb connection for the oxygen outlet.
Be sure to read the entire manual before installing and operating
the unit.
5.2 Pre-installation Operational Check
Although every oxygen generator is tested thoroughly after it is
manufactured, perform the following test to ensure that no damage
occurred during shipping and handling:
1) Make sure the enclosure fastens securely to the unit.
2) Make sure the gross particle filter (See Figure 4.1) completely
covers the air intake.
3) Make sure the power cord connects securely to the power cord
connection (See Figure 4.1) on the unit.
4) Connect the power cord to a properly grounded electrical outlet.
5) Set the l/O power switch (See Figure 4.1) to
l
. Verify that the
green indicator light on the switch illuminates.
6) Listen for the sound of the air compressor (See Figure 4.1) in
operation.
7) Verify that exhaust air emits from the air exhaust (See Figure
4.1) on the left side of the enclosure.
8) Rotate the knob on the flowmeter (See Figure 4.1) clockwise
until it stops at the fully-closed position. Verify that the flowmeter
indicates zero flow.
9) Rotate the knob on the flowmeter counterclockwise until the
flowmeter indicates the flow specified in Appendix A for the
particular model of oxygen generator with nothing connected to
the oxygen outlet. The ball in the flowmeter should rise and the
oxygen pressure gauge should register 62 kPa (9 psig) for
Topaz
and 138 kPa (20 psig) for
Topaz+
and
Topaz Ultra
. If
this does not occur, contact the AirSep Commercial Products
Service Department.
10) If flowmeter setting is disturbed during shipping, adjust the
flowmeter to the flow rate specified. Refer to Appendix A for the
specified flow rates.
11) Set the l/O power switch to
O
.