AirSep AS-A, Инструкция по эксплуатации

Страница: 29 / 192

AirSep
®
Corporation
AS-A—AS-P Series Instruction Manual 5-3
5.3 Installation Instructions
Refer to Figure 5-1 below for the recommended installation arrangement for the
oxygen generator.
Figure 5.1: Typical Installation Arrangement
1) Connect the red air hose provided with the oxygen generator accessories
from the on-site air supply to the feed air inlet connection on the oxygen
generator. Refer to the Table 5-1 to determine the proper size for the feed air
inlet connection and feed air hose for your model.
Series Feed Air Inlet Connection Size Feed Air Hose Size
AS-A,AS-B
¼” NPT female bulkhead fitting with a ¼”
NPT male x ¼” NPSM ball-end joint
adapter ¼” ID minimum
AS-D
¼” NPT female bulkhead fitting with a ¼”
NPT male x
Ǫ ” NPSM ball-end joint
adapter
Ǫ ” ID minimum
AS-D+ 3/8” NPT Female fitting 3/8” ID minimum
AS-E
½” NPT Female fitting ½” ID minimum
AS-G,AS-J,AS-K ¾” NPT Female fitting ¾” ID minimum
AS-L 1” NPT Female fitting 1” ID minimum
AS-N,AS-P
1-1/2” NPT Female fitting 1-1/2” ID minimum
Table 5-1 Feed Air Connection Sizes and Hose Sizes
2) Install your oxygen receiver. If AirSep Corporation provided your oxygen
receiver; assemble the receiver as follows (if not assembled):
Red Air Hose
Oxygen Hose
Oxygen Hose
Pressure Regulator
Kit