Airport 828HC, Инструкция по эксплуатации

Страница: 22 / 49

12
© Airport Lighting Company
5.0.1 Accessing the Configuration Menu
From the CCR main screen, press the CONFIG button once.
You will be prompted for a password. The password on all Airport Lighting Company CCRs is
“9999”. Use the UP and DOWN buttons to change the number above the ↑ up arrow cursor.
Press the right DOT button to advance to the next digit. Once the password is entered, push the
left DOT button to advance to the menu.
5.0.2 Accessing the Diagnostics Menu
From the CCR main screen, press the CONFIG button until you see the “Enter Password” screen.
Press the CONFIG button once more, for a total of two (2) times.
While most of the options within this menu will be used only by Airport Light Company
representatives during troubleshooting, there are menus that contain logs of the 10 most recent
Faults and Warnings, as well as a run-time log.
The Run-time log can be found by navigating to:
Diagnostics Menu > Operations
The Fault and Warning logs can be found, respectably, by navigating to:
Diagnostics Menu > Faults / Warnings
5.1 Common CCR Configuration Changes
This section will go over the most common CCR changes that may be warranted in-field. Note
that configuration beyond the options covered in this section may cause problems with the
normal operation of the CCR. Exercise caution when changing options. For assistance or
clarification regarding options within the configuration menu, contact Airport Lighting Company.
5.1.1 Changing the Step Count of the CCR
The CCR will be factory-configured to the brightness step count that is ordered. It may be
determined in-field that the factory-configured step count is not appropriate for the applicable
circuit and a brightness step count changeover is required.
Note: Follow all appropriate FAA Advisory Circular documentation. Refer to product-specific